DLC World Badge Passes!

Step 1 – Open the Catalogue
Furni → Hot now → NEW: DLC World Badge Passes!

💎 Cost: 1000 Stars
Earn stars via Quests

Step 1 - DLC Worlds

• In the hub room select DLC world by using the down arrow and green button.
  

Step 2 - MAP

• Purchase worlds in the shop with your stars you received from previous worlds in the quest.
• You MUST be wearing the badge you purchased to access the DLC worlds.
  

Step 1 - DLC World: Mechatronic Mode Quest 1/3

• Purchase the DLC Badge 3 for 1000 stars.
• Press the green button to start.

🎉 DLC Pass 3 Badge Awarded:

Step 2 - Section 1

• Make your way across using the rollers and gates.
• Avoid collision with the moving robot.
• Make sure the color tile is completely Green before stepping on it.
• Follow the blue pillow it will move between the rollers.
• You now have a checkpoint.
  

Step 3 - Section 2

• Make your way to the end using the rollers and gates
• Avoid collision with the moving mouses and turn the tiles green
• Each section has a checkpoint
• The Last color tile has to be green when you step on it Enter the gate when its not fully green like shown below
  

Step 4 - Section 3

• Make your way across using the gates and rollers
• Step on the color tile when its Green.
• You must enter the gates in the order shown below.
• Once completed you will have another checkpoint.
  

Step 5 - Section 4

• Make your way across the room only stepping on the flame tiles when they are down
• Follow the moving color tile back and forth until its green.
• Cross the green tiles soon as the first sheep hits the color tile
• then step on the last flame tile to complete the level.
  

🎉 Badge Awarded:

Step 6 - Quest 1/3

wear your Mechatronic Zone badge to complete quests 1/3

Step 3 - DLC World: Inside A Painting

• Purchase DLC Pass 1 for 1000 Stars
• To select this world click the green button
• When you enter click on one of the ducks to enter the queue.

🎉 DLC Pass 1 Badge Awarded:

Step 4 - Step 4

• You have 15 minutes to complete this puzzle.
• You need to re create this picture shown below by sliding the pieces in the correct place.